[ARCHIVED THREAD] - Having Trouble Getting Disconnector In

Posted: 1/25/2005 11:25:33 AM EDT

I'm having trouble getting the disconnector in. The pin doesn't seem to want to line up. I noticed the spring has one side that is slightly oversized and is preventing the disconnector from fully compressing into the trigger. Is this normal?

Posted: 1/25/2005 11:40:55 AM EDT

[#1]

I normally install the end of the spring with the larger circumference into the Hole in the trigger. Then place the disconnector on top.

The Pin should be able to slide through the trigger and disconnector before you try to assemble it inside the lower.

Posted: 1/25/2005 11:49:11 AM EDT

[#2]

that is correct, the wider part of the spring should go in the trigger (down), this locks the spring in place.

putting the pin thru when installing the trigger and disconnector in the reciever can be a pain in the balls, it usually takes alot of wiggling. You can do it tho

Posted: 1/25/2005 11:49:12 AM EDT

[#3]

Got it! The problem I was having was, I would put the oversize in the notch of the disconnector instead of down in the hole. I got it now. :) Again, thanks!

Posted: 1/26/2005 12:43:55 PM EDT

[#4]

Hell, just leave it out..............................................You like prison food, don't ya

WIZZO

[ARCHIVED THREAD] - Having Trouble Getting Disconnector In

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Having Trouble Getting Disconnector In

[ARCHIVED THREAD] - Having Trouble Getting Disconnector In