[ARCHIVED THREAD] - Accu-wedge

Posted: 11/18/2004 9:32:31 AM EDT

How does this part work/mount?

Posted: 11/18/2004 9:45:54 AM EDT

[#1]

What is it they say about a picture???????

Mike

added: for tightening your slack between the upper and lower, they work fine.....

Posted: 11/18/2004 9:54:23 AM EDT

[#2]

You may find that you have to slice off the bottom a little, depending on how tight your two receiver parts are. On my Colt, I almost had to trim off half of it, using an X-acto knife.

hope this helps.

Posted: 11/18/2004 10:31:20 AM EDT

[#3]

Quoted:
You may find that you have to slice off the bottom a little, depending on how tight your two receiver parts are. On my Colt, I almost had to trim off half of it, using an X-acto knife.

hope this helps.

Chinese made copies of the accuwedge always need trimming, most of the real American made ones fit without a problem.....

Unless your dealing w/ a RRA lower which has a shallow rear shelf, in which accuwedges don't fit at all.

Mike

Posted: 11/18/2004 10:33:42 AM EDT

[#4]

Just stick some old chewed up bubble gum in there!

Posted: 11/18/2004 10:56:30 AM EDT

[#5]

Use a rubber Oring around the front take down lug instead. I would not force an Accuwedge on anyone. I threw mine in the trash the first time I tried it as I had to use a tool to open my reciever even after I trimmed it.

Posted: 11/18/2004 11:37:25 AM EDT

[#6]

Quoted:
Use a rubber Oring around the front take down lug instead. I would not force an Accuwedge on anyone. I threw mine in the trash the first time I tried it as I had to use a tool to open my reciever even after I trimmed it.

Got a pic and/or a size of an O-ring?

[ARCHIVED THREAD] - Accu-wedge

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Accu-wedge

[ARCHIVED THREAD] - Accu-wedge