AR Sponsor
Posted: 2/19/2004 3:36:39 PM EDT
Well my AR build is done. Came out pretty good. I discovered I had the hammer spring in upside down after it was all done, only took a couple of minutes to fix. I had to cut a couple of coils off the pivot/takedown pin detent spring. It stuck to high out of the hole and I couldnt get the detent pin in. Finally succeded. If I ever make another I'll buy the litle tool that slides thru the pivot hole and has a little hole in it to put the spring and detent, I can see it would be a very handy little tool to have. The one I just finished is the middle one, RRA lower with a Bushmaster upper. Think one of these days I'll buy another lower and put it together just to sell, I took the new lower to a gunshow just for a couple of parts I needed and was asked if it was for sale a hundred times. It was just the lower with the PG and butt stock , I needed a roll pin for the bolt latch. Of course the guy I needed to see didnt show up, had a friend that give me one tho so it wasnt a bust. Next build will be a breeze.
|
AR Sponsor