AR Sponsor
Posted: 7/21/2003 3:17:54 PM EDT
|
OK. This might be a fairly easy question, but I don't want to start applying real pressure til I'm sure about this. I have an SP1 which I had a collapsable stock put on. I wish to return it to original with an A1 stock. But, I have never seen or done a stock removal or installation. I applied a bit of torque with my hands on the reciever and buttstock to remove the stock and felt zero give. before I start playing gorilla, is there some trick to this? Thanks |
|
Quoted: .... is there some trick to this? Thanks Just knowing what you're doing. Near where the receiver extension (commonly called buffer tube) meets the lower receiver you'll see a spanner type ring (ring with a couple of holes in it). This is threaded and works as a locking nut. You should use an appropriately sized spanner wrench and loosen this ring. As the ring is loosened there is a tear dropped shaped plate that abutts the receiver. This plate holds the rear take down pin and detent in. Watch for it as you back off the ring. Once the ring is backed off pull that tear dropped plate away from the receiver (catching the spring and detent) and then unscrew the receiver extension (buffer tube). Watch for the buffer stop pin and it's spring in the receiver. It is held in place by the receiver extension. You will need a new receiver extension for the A1/A2 stock (A2 uses a spacer and longer butt screw). This installs pretty much the same way only backwards from the previously described disassembly only without the tear drop plate thingy. Thread the extension into the receiver and when you're close enough insert the rear take down pin detent and spring in the recess (make sure the take down pin is in place). When the front end gets close to the hole that holds the buffer stop pin, put that spring and pin in the hole, press it down with your thumb and scew the extension up until it stops. A good hand tight twist is all you need. Slip new A1 stock on and screw in place with appropriate butt stock screw. |
|
Thanks. I basically don't have anything that will loosen the locking ring, which BTW only has a single hole in it? Seems to have two marks where someone else (the installer perhaps) put something on it to torque it. Dunno. I got nothing that will work. Guess I gotta pay the piper at the gunsmith again (sigh). Or buy the tool. Hmmm. Thanks again. |
| That same tool is built into the DPSM armorer's wrench...if you think you'll be installing/uninstalling barrels, float tubes, etc, you're gonna need one of them. You could put that $5 towards the armorer's wrench...which is considerably more expensive, but useful for a variety of purposes. The old "pay me now, or pay me later" syndrome that AR-15 owners know all too well [:D] |
AR Sponsor