Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
Posted: 6/3/2003 8:10:59 PM EDT
I'm just about ready to assemble, but my parts kit might have included a defective hammer spring. My spring lays almost flat if laid down on a table. there is a slight angle to it, but not nearly as much as in the picture in the instructions. do i have a problem?
Link Posted: 6/3/2003 8:13:44 PM EDT
i actually just assembled mine a few minutes ago, i did notice that the spring didnt match the directions, but it went in ok, i think it was the hardest step
Link Posted: 6/3/2003 9:43:41 PM EDT
LOOKS LIKE M16 PART BURST CAM HAMMER SPRING OR IM MISTAKEN EXCUXE ME ...
Top Top