AR Sponsor
Posted: 5/23/2003 8:02:35 AM EDT
|
I have a upper with a Wilson Tact brake on it that I want to remove. I think it is a Wilson install but can see no weld or pin hole. Bought upper at a pawn shop so unsure. It will not turn with out high amount of pressure. I think they weld over pin hole but should it be on top or bottom of brake? Can I grind down and then drill out pin and unscrew brake? Yes I do have a pre-ban lower to put it on. The reason I bought it was it had a fluted Bushmaster barrel. Any Help? |
|
Removal 101--- grind carefully almost to the threads, slight twist and front will seperate from rear, light heat the rear, use pair of "grips", unscrew rear....This was a 5.5 on a Bushmaster, never did see the pins, just the 2 holes in the threaded area. [img]www.imagestation.com/picture/sraid60/p891547a10c820cea808bcb4822a50566/fc510dd6.jpg[/img] |
AR Sponsor