AR Sponsor
Posted: 2/3/2013 11:27:46 AM EDT
|
I recently purchased my first QD mount and am not sure how to gauge the tightness for the QD levers. With other mounts, I simply set the torque driver to spec and go. Any suggestions on how best to get adequate torque and still be able to close levers? Or is this just a trial and error process?
Many thanks for your advice. |
|
Quoted:
Trial & error.. It's a bit of a pita to get 'em both adjusted to where you like. I have mine where it takes a good bit of pressure to close them. But once I got it set it seems to keep the setting after removal / re-mounting several times. Yup, trial and error. If there was another way I got to figure the Burris people would have went ahead and put some damned instructions in the package. 
Fortunately, it's not terribly difficult to work through. Just take a good close look at how it works and you'll figure it out. |
AR Sponsor