[ARCHIVED THREAD] - S.A.M. clone optics setup

Posted: 6/9/2004 11:03:05 AM EDT

Hey guys, if I wanted to mimic the height of rings on new MarCorps SAM-R rifles, with Warne rings, anyone know what height I should get for a good cheek weld? and have it fit over an ARMS 40? Keep in mind I have the flip down front sight, thanks again.

Shawn

Posted: 6/9/2004 2:39:17 PM EDT

[#1]

I use Warne Ultra-High quick release rings, which puts the center of the scope at the same height as the A2 iron sights. My Leupold just barely clears my ARMS #40. Normally, I despise vertical split rings, but these work well.

Warne Rings

Posted: 6/9/2004 3:06:37 PM EDT

[#2]

I think I have the Warnes Extra High Ring (but I am not positive) and they allow my Accupoint to cleat the Knights 600M BUIS

EDITED: After closely examing the pic of the Ultra High rings, mine are definitely the Extra High.

Posted: 6/9/2004 4:38:20 PM EDT

[#3]

I don't know if that pic of the high, extra high or ultra high. It was just a generic Warne picture from the Brownells site.

Posted: 6/10/2004 6:52:29 AM EDT

[#4]

Warnes Website would be much better if they gave the centerline ring height.

Just got a rough number for my ring. Approx. 1.45" to the centerline. I also changed the BUIS to the Troy Ind. and there is a 1/8" gap between the rear objective and the BUIS.

[ARCHIVED THREAD] - S.A.M. clone optics setup

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - S.A.M. clone optics setup

[ARCHIVED THREAD] - S.A.M. clone optics setup