AR Sponsor
Posted: 2/19/2008 4:37:44 PM EDT
| I think the ejector/extractor on my ceiner is FUBAR'D ..... its still in one piece but the end where it would grab the rim of the case doesnt look right to me .... anyone got a pic of what it SHOULD look like ... Id take a pic of mine but I dont have a farking clue as to where my digital is and all I have is a cheap webcam that wont take a good enough pic of it |
| ok ... so it just may be that mine is "different" .... I bought it used and it didnt run exactly right the first time I ran it and this was the first time I was able to take it apart and polish it up and actually take a look at it. Im hoping I get a chance to put some downrange again this weekend ..... but its hard to shoot something that doesnt run right 100 percent of the time when I can reach over and pick up my GSG and it runs perfectly |
HA ..... conversion kit is NOT going anywhere ...... Ive been searching around forever for one .... bought this one used here on ARF.com and really felt good about it .... all the proceeds went to an officer that was stabbed in the femoral artery and damn near died while off duty working at a shopping center as a guard. Got the kit and 5 BDMS for 275 ETA ............. yeah ... thats exactly what mine looks like ............ I guess its not fubard |
Most likely problem is mag lips a little to high if it is pulling them out of the chamber , but not flipping them out the sid . The end of the extractor is supposed to have a little angle on it. Is your mag 10 or 30rd? Try a Blackdog full body and your problem might go away. |
AR Sponsor