AR Sponsor
Posted: 11/24/2012 9:35:20 AM EDT
So now that Jhud is taking a break of course I find myself wanting a set of mid-length triangular hand guards. I know Nodak used to make them but they no longer do. Anybody know of another source? My Google-fu is weak on this one. 
|
|
you can do what we did a few years ago when we first started using mid length gas for retro inspired carbines, and just cut the front of the HG off about an inch from end, slide it back into the HG and glue it to get the length you need with the correct ends to fit the slip ring and triangular front cap.
here's a pic from an old 6.8spc project mock up I did a few years ago ... 
|
|
Quoted:
Quoted:
here's a pic from an old 6.8spc project mock up I did a few years ago ... http://i151.photobucket.com/albums/s147/crackedcornish/df740b42.jpg Man, that is one long-ass buttstock!!!  You must have arms like a gorilla!!! 
I lost the URL for Tony's...Does anyone have it handy??? Tony's Custom Uppers? http://www.tonyscustomsllc.com/ New website under construction. |
|
Quoted:
Quoted:
here's a pic from an old 6.8spc project mock up I did a few years ago ... http://i151.photobucket.com/albums/s147/crackedcornish/df740b42.jpg Man, that is one long-ass buttstock!!! You must have arms like a gorilla!!!
I lost the URL for Tony's...Does anyone have it handy??? postino, that stock wasn't installed when the mock up pic was taken...the lower rod wasn't cut yet, so it's just laying under the receiver to give me an idea of how it was going to look...and yes I do have pretty long arms 
...and I don't recommend Tony's...terrible CS |
AR Sponsor