AR Sponsor
Posted: 9/27/2011 2:01:16 PM EDT
Got one of those m16a1 kits that came with the new barrel it needs to be parked and the fsb installed. My local ffl doesnt want to chance messing it up so if anyone knows someone who can do this for a nominal fee  ljust let me know thnx.
|
|
Quoted:
Got one of those m16a1 kits that came with the new barrel it needs to be parked and the fsb installed. My local ffl doesnt want to chance messing it up so if anyone knows someone who can do this for a nominal fee ljust let me know thnx. The nominal fee is the pisser Troop. Same situation here and the service is not cheap and the wait to get your stuff back can be long for the cheaper places and expensive at the faster places. Ask me how I know! There may be those on the boards that can do it but if they offered their services they would be swamped with requests! PS If anyone wants to PM me an offer of inexpensive and relatively quick service...........
|
| I read your thread this morning in the Texas hometown forum. If I was in your position, I'd send it out to be installed. Many here recommend ADCO. I've never used them before, but I would in a heartbeat based on the recommendations and photos of their work posted here. |
|
Quoted:
Got one of those m16a1 kits that came with the new barrel it needs to be parked and the fsb installed. My local ffl doesnt want to chance messing it up so if anyone knows someone who can do this for a nominal fee ljust let me know thnx. grayparatrooper, Send me an email; I can help you out with your project. My address is [email protected]. John Thomas |
|
Quoted:
Quoted:
Got one of those m16a1 kits that came with the new barrel it needs to be parked and the fsb installed. My local ffl doesnt want to chance messing it up so if anyone knows someone who can do this for a nominal fee ljust let me know thnx. grayparatrooper, Send me an email; I can help you out with your project. My address is [email protected]. John Thomas Email sent.
|
.
|
I used a drill press with a large add on table from harbor Freight. I used a 1/8 end mill to to flat spot it and then a drill bit I did the tapered reamer by hand. Quoted:
Quoted:
Putting the FSB on is a peace of cake with the above mentioned jig. I have done two with mine took less than an hour with changing bits and taper reamer. f4enut Are you using a Mill or a drill press? |
AR Sponsor