AR Sponsor
Posted: 5/16/2014 2:59:57 PM EDT
|
Looking to make my 1st attempt at assembling this variant.
I admit I am fairly new to this platform but I am good with my hands. When it's done I hope to have an accurate long range bench top shooter. I'll never be able to see that far but it will be nice to have a stick capable of reaching out there. Cost does influence my choices to some degree but I want to try to put money where I think it will be best served. I have my stripped upper & lower & will research parts for the lower later. I want to finish the upper 1st. I have selected a DEZ Arms barrel. Twister I am now looking at LP gas block assemblies or separate parts. This complete assembly caught my eye. Wilson Combat The question is will the 1/1000th difference in the diameter be an issue? Barrel spec is 0.936, gas block spec is 0.937. The plan is to use a quad rail long enough to extend just past the gas block. If you have suggestions for the rail & barrel nut to accomplish this that would help. Thank you all for any advice you can offer. |
AR Sponsor