AR Sponsor
Posted: 3/15/2014 11:10:15 PM EDT
|
From here: http://www.ar15.com/forums/t_3_121/413443_.html
I found this quote, From DnPRK: Most AR trigger assemblies will fit an LR-308. The two triggers that require modification are 1) the Chip McCormick straight trigger which needs th end of the trigger clipped to clear the trigger guard and 2) the RRA trigger which might require the tip of the cocked hammer to be clipped to prevent it from dragging on the bottom of the bolt carrier. Does this mean that most AR-15 trigger assemblies do *not* fit the AR-10 platform? Second, where can I find a list or diagram of *all* AR-10 parts? That list shows me what's interchangeable, but it doesn't tell me what else exists. Thanks! |
|
I have another question: I read that I can put AR-10 uppers on LR308 lowers, but there will be a gap.
Is the gap internal, or external? If it's external, will someone please show me a picture? Quoted:
Check the faq in the Armalite AR10 and 180 section. Tells you everything you need to know. Where do I find that? |
|
Do you mean the link I pasted in my OP?
Quoted:
As far as the Armilite Ar10 upper and DPMS lowers. There will be a gap. The DPMS has a rounder upper Rec. Like a std. Ar15. The Armilite has a more Squire upper rec. Look at the top of the page in yellow. Fequently asked questions. Hope this helps. |
AR Sponsor