[ARCHIVED THREAD] - KNS trigger pins install????

Posted: 3/23/2014 7:34:48 AM EDT

I installed new KNS triggerpin set yesterday and the the hammer would fall when I released the trigger not when pulling it like normal. Watchedthe youtube video finally replaced original pins and works normal that way. Any help???

Posted: 3/23/2014 7:37:06 AM EDT

[#1]

That is a known issue with KNS pins.
If You had no issue with Your pins walking before the KNS install, just continue to use the Mil-spec type pins.
Get rid of the KNS pins and enjoy Your rifle the way it was designed.

Posted: 3/23/2014 8:12:37 AM EDT

[#2]

Thanks wish I knew about that before I spent good money on a backwards trigger.

Posted: 3/23/2014 8:23:09 AM EDT

[#3]

It sounds like your disconnector didn't get re-installed correctly, like the spring wasn't installed. You DID get the "standard" diameter, 0.154" KNS pins, right? Not the over-sized 0.155" version? Because an over-sized trigger pin can also keep the disconnector from working. correctly.

Posted: 3/23/2014 8:25:05 AM EDT

[#4]

[ARCHIVED THREAD] - KNS trigger pins install????

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - KNS trigger pins install????

[ARCHIVED THREAD] - KNS trigger pins install????