Anyone know where to get one without much hassle, shipping cost?
Thanks!
Posted: 5/31/2012 4:49:35 PM EDT
[#1]
all my local gun shop (excluding box stores) have them in stock. not sure about yours, though.
edit: parts like that are easy to stock up on if you have gun shows near you. odd parts like that are the only thing i purchase at shows any more.
Posted: 5/31/2012 4:51:54 PM EDT
[#2]
Ok, thanks. I'll check around.
Worst case scenario, ADCO is about 45 minutes from me.
Posted: 5/31/2012 5:08:11 PM EDT
[#3]
Quoted: Worst case scenario, ADCO is about 45 minutes from me.
Bingo.
Good opportunity to convert to taper pins.
Posted: 5/31/2012 5:09:55 PM EDT
[#4]
I probably should, but this rifle is sctrictly a range toy, and I'd like to keep expenses down for right now.
Posted: 5/31/2012 8:14:29 PM EDT
[#5]
I just drove out both pins from an RRA FSB that I'm not going to reuse a few minutes ago. IM me your address and I'll mail 'em to you.
Posted: 5/31/2012 8:18:26 PM EDT
[#6]
Ok, thank you so much!
Posted: 7/5/2012 12:32:59 PM EDT
[#7]
I've com e to the conclusion that they got lost in the mail lol
Posted: 7/5/2012 12:38:12 PM EDT
[#8]
Did you try contacting RRA?
They may be able to ship one out.
Posted: 7/5/2012 12:45:43 PM EDT
[#9]
I live about 45 minutes from ADCO, they have them. I've just been a bit busy.
I'm afraid to go to ADCO for a $2.00 pin. I may buy something expensive to make the trip worth it!
Posted: 7/5/2012 12:52:11 PM EDT
[#10]
Quoted: I live about 45 minutes from ADCO, they have them. I've just been a bit busy.
I'm afraid to go to ADCO for a $2.00 pin. I may buy something expensive to make the trip worth it!
I see...
Posted: 7/6/2012 8:34:17 AM EDT
[#11]
IM me with your contact info and I can just send you one.
Do you mind if I ask how you broke the pin?
Steve/RRA
Posted: 7/6/2012 9:19:55 AM EDT
[#12]
Thank you, although im more than happy to pay you for it.
I was just driving the pin out with a small punch. It was the second time i had removed them, and it just shattered. If it matters, they weren't hard to remove. They did not take much force.
Posted: 7/6/2012 9:24:16 AM EDT
[#13]
Just do what Ak guys do. Tap in a drill bit shank and cut off the flutes.
