AR Sponsor
Posted: 1/27/2012 10:06:21 AM EDT
|
I'm thinking more for trigger, hammer and sear.
Does anyone do this? Is there reasons not to? I like the idea of not attracting dust and debris. I don't think that it graphite has the rite properties for the bolt, but has anyone heard of that? |
|
Galvanic corrosion can be a problem with graphite when it's in contact with aluminum unless it's kept within a suspension like oil or grease, it's also hygroscopic and is harder than aluminum and can cause accelerated wear... no reason to not use proper lubricants... |
| This article on graphite as a weapon lube is from the Army's PS Mag, the monthly magazine they put out for soldiers concerning preventative maintentance on their equipment: http://findarticles.com/p/articles/mi_m0PCA/is_632/ai_n14842166/ |
|
Quoted:
Thanks all, now I'm glad I asked rather than just gave it a try. If you are looking for a good lubricant for your AR that stays put and doesn't burn off, go to your local AutoZone and buy a quart of Mobil1 synthetic motorcycle motor oil, and a quart of Mobil1 synthetic ATF. Mix them in a 50/50 ratio and give it a try. I started doing this a while back based on a recommendation from a friend who is an armorer at SigArms, and I've been very happy with the results 
Two quarts of "ingredients" will last you a very long time, and it won't break the bank. If you'd like to try before you buy, I'd be happy to find a little container to donate and ship some your way. You'll just need a way to apply it-I use a needle oiler from Brownell's. Posted Via AR15.Com Mobile |
AR Sponsor