AR Sponsor
Posted: 5/13/2011 9:35:31 PM EDT
|
Does anyone have a schematic or even a listing that shows the the acceptable mil spec tolerances?
I am just curious as to where my rifles stand. Mostly looking for lower dimensions Thanks |
|
Some available here too.Scroll to the bottom of the page.
http://www.ar15.com/content/index.html#manuals |
|
Quoted:
Some available here too.Scroll to the bottom of the page. http://www.ar15.com/content/index.html#manuals None of those files work Thanks though |
|
This one doesn't work for you?
http://www.ar15.com/content/manuals/lowerBlueprint.pdf NM, didn't realize you already found what you needed. |
|
Quoted:
Quoted:
Does anyone have a schematic or even a listing that shows the the acceptable mil spec tolerances? I am just curious as to where my rifles stand. Mostly looking for lower dimensions Thanks Does everything fit together as it should? Well yes the firearm itself it fine. I was having an issue with one of my old Pmags, I started a thread about that in the magazine section, here The older Pmag I have does not drop free from the lower, all the new ones I have drop with now problem. I miced the old one and it is .914" and the mag well on the lower receiver is .898" Seems to me Magpul did not do a very good job with QC at some point... |
AR Sponsor