[ARCHIVED THREAD] - Surefire MB556K

Posted: 2/13/2009 5:31:33 PM EDT

i recently purchased a surefire muzzle brake and was curious if anyone knew if there were any special steps to follow when installing it. hand tighten? tighten to a certain torque weight? it did not come with any installation instructions and i have looked on line with no luck.<br />thanks

Posted: 2/13/2009 5:37:38 PM EDT

[#1]

Quoted:
i recently purchased a surefire muzzle brake and was curious if anyone knew if there were any special steps to follow when installing it. hand tighten? tighten to a certain torque weight? it did not come with any installation instructions and i have looked on line with no luck.<br />thanks

It should have come with a vial of rockset, shims, and instructions.

You use the shims to index it correctly, there is a sheet that helps you figure out which shims you need.

Posted: 2/13/2009 5:37:45 PM EDT

[#2]

Try the AR " Build it Yourself" forum...

AC

Posted: 2/13/2009 5:42:13 PM EDT

[#3]

If you actually plan on using one of their cans, use the Rockset and washers supplied.

If you don't plan on using one of their cans, a crush washer will work fine too (much easier than the timing process...).

Posted: 2/13/2009 5:47:28 PM EDT

[#4]

at the moment i dont plan on using one of their cans. so... i just need to use a crush washer and tighten how much?

thanks

Posted: 2/13/2009 5:48:44 PM EDT

[#5]

Usually until the notch lines up on the bottom.

[ARCHIVED THREAD] - Surefire MB556K

AR Sponsor

Warning

Confirm Action

[ARCHIVED THREAD] - Surefire MB556K

[ARCHIVED THREAD] - Surefire MB556K