AR Sponsor
Posted: 2/29/2008 4:52:35 PM EDT
|
My buddy is holding a Colt barrel SPR with LaRue gas block for me. I need a nice rail that mates up flush with the upper. I know DD and LaRue rails have the big ring against the receiver but I was looking for a rail that offers continuous surface from upper to forearm. Suggestions? RR |
|
+1 for the DD Lite Rails. Very high quality as well. You can also get the PRI FF tube and use the ARMS PEQ rail as used in the SPR Mk12 MOD0 rifle. ETA: SWS rails also provide for a continuous top rail. I currently use a mid length SWS rail on my SBR. It is a high quality rail and is in use by Noveske, a very reputable barrel maker/AR builder. |
|
I wouldn't mount a scope with one clamp on the receiver and the other on the handguard, or any part of the mount touching the handguard, even if others have done so without apparent problems, unless it's an LMT MRP or Vltor's VIS. I have DD's 14.0 Lite Rail and SWS's handguard for my AR10s, the "continuous rail" handguards do render a few more rails where the void for the handguard nut would have been, but I can't think of any use for these extra rails there. DD Lite Rail 14.0  SWS 
|
Go for the LMT MRP, they're now $200 cheaper, I'm thinking of getting another one 
|
Dont forget PRI...they started all this...PRI Check out the carbon fiber fore-end. You can get two different top rails, the ARMS one or PRI's Rifle Rail. B |
   I KNOW A GUY WHO DOES A LOT OF BUILDS WITH THE KAC URX ..... WES GRANT MSTN.BIZ |
You know him too? 
|
AR Sponsor