Posted: 8/18/2013 9:21:16 AM EDT
|
Hey guys,
I just purchased a Geissele 2 stage trigger for my ar15 colt rifle. I followed the instructions to the letter, the install did not seem to be any different than any other fire control group install. I used there trigger/hammer pins, disconnector spring, there trigger/hammer spring, and obviously their trigger and hammer. I did all the functional checks from safe to fire and they all panned out fine. When i put my lower back on my upper and racked the bolt back to measure the actual trigger pull it was somewhere in the 7-8 lb range. I feel the first stage come off at around 3lbs which is where it should, but the second stage almost takes an additional 4-5 lbs to release the hammer??? From their website it should be 4-5 lbs total pull for the trigger to release. I guess my question is where did I go wrong, this is my first two stage and i was very anal about the instructions and following them because it was a $200 trigger . I did add grease to all the parts but even without that I would expect the pull to be less than 8 lbs....thats worse than factory single stages!!! I will admit this is my first two stage trigger so my expectations might be high....something just doesnt feel right with it. any help would be appreciated thanks. |