Can these be used to clamp a barrel in a vise to change out the fh? Also can they be used to clamp an upper in a vice for barrel changes? Haven't seen any real detailed specifics on it.
Posted: 11/16/2011 8:58:09 AM EDT
[#1]
do you have a FSB?
Posted: 11/16/2011 11:07:46 AM EDT
[#2]
Don't mean to hijack your thread but I too have a question about the block. Does it allow for a rock free stable platform for the lower to rest on when hammering the trigger guard pin?
Posted: 11/16/2011 12:34:34 PM EDT
[#3]
yes!
Posted: 11/16/2011 2:12:15 PM EDT
[#4]
Quoted: yes!
Thank God there is finally a nice solution to this!! Hammering away at the trigger guard pin is always a crap shoot with me. When the rest of my build comes together (waiting on lowers from engraver) this will be ordered. Thanks Bryan!!
Posted: 11/16/2011 2:32:38 PM EDT
[#5]
Yes I have a fsb. If the answer for me is yes I will be ordering asap
Posted: 11/16/2011 2:47:05 PM EDT
[#6]
yes you can snug up the fsb in a vise with the blocks around it
You could also put the flat top receiver in the vise sideways, with a wood block on each side, FH don't require to much force
Posted: 11/16/2011 7:31:15 PM EDT
[#7]
Sweet. Will be putting in an order tomorrow. Thanks
Posted: 11/28/2011 1:56:49 PM EDT
[#8]
I've got my blocks now I will put them to the test I have 3 lowers to assemble Saturday. I didn't end up ordering until the 22nd I believe and they came today. Big thumbs up to aim.
Posted: 12/2/2011 9:24:19 PM EDT
[#9]
r guns blocks are gtg. i used them today on two builds
