Posted: 11/28/2012 12:31:43 PM EDT
I sent in a new barrel I tried to remove the gas block taper pin on... It was a disaster, the pin mushroomed and I couldn't get it to budge. I ordered the FSB taper pin upgrade after reading this thread http://www.ar15.com/archive/topic.html?b=2&f=130&t=202843 so I hope that's the right service for you guys to remove the stuck pin and fit a new one. I also marred up the low pro gas block pretty bad and was hoping you could either refinish or replace it and forgot to mention that in the comments section. Do you have any advice for getting these pins out? My order number is 38228835 and the barrel should be delivered tomorrow... I hope you guys can help I did enough damage already 
|
Noted on the order to take a look and see what we can do with the GB. Also, need you to email me your street address, it did not get put on the order. Only need number and street, have the rest, to [email protected], so i can put it on the order. 
|
|
Quoted:
Noted on the order to take a look and see what we can do with the GB. Also, need you to email me your street address, it did not get put on the order. Only need number and street, have the rest, to [email protected], so i can put it on the order. I sent Dave the info.... Looks like I was scatter brained putting my order in, I get like that after damaging my firearms 
|