Posted: 8/22/2007 4:04:10 PM EDT
|
I have a Stag Arm left hand upper. I would like to have the barrel cut from 16" to 13" and have a noveske kx3 flash suppressor permanently attached. I would also like to have a low profile gas block installed and pinned along with installation of a yhm free float hand guard. on your form I would check Attach perm install muzzel device $25 cut thread and crown barrel $65 Disassemble reassemble upper $50 I dont see a box for pinning the gas block or installing the free float hand guard. What do I do for these options. I will be supplying all the parts. Also what would be the approx turn around time for this. |
Add a note in the comment section for pinning the block - its $20 $50 for installation, listed under disassemble/reassemble I would REALLY rethink the perming of the KFH to the 13" barrel. We've done a bunch of them, and usually end up taking them back off in a month or so. It has no purpose on a barrel that long, other than the 1/2lb of dead weight. |
|
Thanks for the reply but I'am still interested in doing this set up. I really like the looks of it. Also do you have an approximate turn around time for this type of job. I should have all my parts in by next week and would be sending it out by the end of next week.. Thanks |
| I don't want to be a pain in the A$% but I was in the process of filling out the order form tonight with the options I wanted which was attach perm muzzle device, cut, thread and crown ,disassemble-reassemble. You said just to add the pinning of the gas block for $20 in the comments section but how do I add the $20 to the cart?? Do i just put a money order in the box along with the upper and the parts or is there another way to add it to the shopping cart..Again sorry for my not understanding but I just want to make sure I do this right.. |