Posted: 11/1/2013 6:04:45 PM EDT
|
I installed wsjtx fine & have CAT control over rig. I followed the directions on setup & I can see data on the waterfall, but I'm unable to decode anything. I double click on the data stream & nuttin. I was able to open the sample files & decode them correctly. I'm almost there, but something is not quite right. Anybody use a TS-590S in JT65 mode? Maybe I have a menu setting wrong, got me stumped.
Trying it on 14.076.00Mhz Any help greatly appreciated. HS |
| Maybe your computer clock is not synced accurately enough. Have you tried using Dimension 4? |
|
It's going to be time related but.....
First check your sound level in the lower left corner. Someone posted they use about 40db on that meter move the slider down until you're in that range. Time: Transmissions go from :00 on the minute until :50 on the minute. The last 10 seconds of every min for decoding. If you are not hearing sounds start at :00 and stop at :50 your time is off. Use something like D4 or even go into your clock and make it sync from the time server instead windows. Have it update now. |
|
OK, I'm in the game now!! It was my timing. Seeing all kinds of good stuff now!
Just decoded some Canadians, MN, WA, & even a Russian call, holy cow! -- On 7.076.00Mhz Now to figure out how to do a QSO without botching it too bad 
Thanks again fellows... Man I'm gonna be up all night now 
HS |