|
Board straighter looks like it could go around a door handle/ knob, and be used to pop the handle out, and if it doesn't come out, at least open up a gap to get the pry in. Probably a lot less noise than smashing the lock off, or battering the door.
Tool would make a good Mono pod if stabbed into the ground. Can't come up with anything else right now. |
I looked at picking one of those up a while back but passed. They look like well built tool. Good Pry Bars and Demo Tools are always a plus to have. The lock on my cheap Gun Cabinet broke a few weeks ago and 20 min. later with the help of two pry bars. One small and one large the problem was solved and the door was ripped right off the face of the cabinet thus freeing my guns.
In addition to the small prybar I would definitely keep a larger one on hand too. |
|
I actually have two of these, one for my rig and one that stays nice at home. I've beat the living hell out of the one in my rig and the only thing that's happened to it is the "dead on" plastic symbol has fallen off. They are very prone to rust but I think it just makes it a meaner looking tool after it has a little rust on it. |
|
Rim Shot
Quoted:
how do you know? Quoted:
Quoted:
It is a lot nicer hammer than the Stanly fubar. I have both. I have the baby brother, and a FUBAR FUBAR is a superior weapon for attacking ice dams. Ask me how I know ![]() I finally FUBARed the last of the ice out of my shaded gutter Saturday after two weeks.
Water running inside the wall and through the window lintel needs attention. FUBAR Ice pick ––- check Hammer ––- Check chisel ––––- Check –– One hand on head, one hand on grip, drive the bottom into the ice wide side –– Check for breaking up ice on top of the shigles, the nail puller at the bottom on the handle bends up so you don't smash your fingers Long Handle ––- Check lots of reach with it |

