Posted: 4/9/2009 7:30:39 PM EDT
|
I will most likely take the San Antonio Class sometime between the 12th, and 15th of may. I will be setting it up sometime this week, early next week, assuming all the paper work goes smooth, and they have an open slot.
Any tips, suggestions, stuff to bring? |
|
Bring a Glock.
I'm not being a wise ass. Glocks benefit from not needing an eloborate kit to work on them. Be well rested and ready to learn. They are simple and the course will give you a great appreciation of the engineering that went into them. A soft cleaning cloth(patches) and your favorite gun oil will be more than enough. |
|
Quoted: http://i307.photobucket.com/albums/nn286/jt556/Brick.jpg http://i307.photobucket.com/albums/nn286/jt556/hammer-1.jpg  Ah! The offishul Glock pin punch block! |
|
Quoted:
Quoted:
http://i307.photobucket.com/albums/nn286/jt556/Brick.jpg http://i307.photobucket.com/albums/nn286/jt556/hammer-1.jpg Ah! The offishul Glock pin punch block!
for profreshunals OP IIRC all you need as far as tool go is a 3/32 punch and small mallet,+ the small bit/ screw driver for the front sight. Glock and Lightning Strike both make a tool for under $20.00 Removing the mag release spring is a pain in the sack, I used a small flat head screw driver, reinstalling will cause more pain in the sack area. |