Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
9/22/2017 12:11:25 AM
Posted: 9/14/2005 9:46:27 PM EDT
Greetings,

I am gathering information about manufacturing a SBS and need some help please! My project is to legaly convert a standard Rem 870 to a SBS and have been told that ATF Form #1 is what I need to complete and then after approval I can have my local gunsmith cut the barrel down.

Is this information correct? Can I use printed copy of ATF Form #1 from ATF website or do I need to order form? Can I posses the shotgun in it's standard 18" barel configuration during the wait for approval? Is there any info available to help me properly fill out form?

Thanks in advance,
Adrian
Link Posted: 9/14/2005 11:35:46 PM EDT
Right here is a kick-ass website. They tell your everything you want to know about NFA stuff.

They also have pre-filled out forms for you. You just fill in the personal info and print it out.

Here is your Form 1. It is PDF format.

Good luck!
Link Posted: 9/15/2005 3:38:49 AM EDT
Yes, you can posses the 18 incher until your SB is approved.


I have seen some folks simply do it without forms as well.


You may check into this, but simply cutting down a 18 inch barrel may give you undesireable ballistic traits, i.e. shoots all over the freaking place. Get a properly backbored 14 incher from Vang Comp!
Link Posted: 9/15/2005 8:15:40 AM EDT

Originally Posted By AZ-K9:
Yes, you can posses the 18 incher until your SB is approved.


I have seen some folks simply do it without forms as well.


You may check into this, but simply cutting down a 18 inch barrel may give you undesireable ballistic traits, i.e. shoots all over the freaking place. Get a properly backbored 14 incher from Vang Comp!



+1 for Vang
Top Top