Armory Sponsor
Posted: 1/31/2015 11:41:09 AM EDT
| I have 4 trifecta muzzle devices that I need to mount on my rifles. I have never used (or heard of) Rockset before. Can't seen to find any definitive instructions on line and the small vials from SS have nothing. I am assuming that the threads need to be cleaned and dried like you would do if using Locktite, the brake/hider screwed on and torqued?? Is rubbing alcohol OK or brake cleaner?? |
|
Quoted:
Silencer Shop or Brownells Quoted:
Quoted:
Where can you buy it? Silencer Shop or Brownells Or Amazon |
|
Test fit the muzzle device and make sure you are using the right shims and everything times correctly.
Remove the muzzle device and clean all mating surfaces, I use Gun Scrubber Dry all mating surfaces, I tend to use compressed air for this, but a clean towel will always do Apply 1-2 drops of Rocksett to the barrel threads Install muzzle device and torque If you have four devices, then you probably only need about 1-2 vials. You can find them at Silencershop, Midway USA and Brownells. If you want/need more than that, you can always buy a 2oz bottle to have around (eBay). Depending on how much Rocksett made it on the threads when you installed the device will dictate what you will need to do to remove it. If only a couple drops were applied, then you should be able to break the seal with a decent amount of torque. If a lot was applied, you can try torque, but I would recommend soaking it in water overnight. |
Armory Sponsor