Armory Sponsor
Posted: 12/13/2008 2:25:11 PM EDT
| I'm putting in my replacement screws. I got to the trigger group. I tried to take it out easily but of course the brass washers went flying. Along with the brass washers another washer, this one with ridges, looks like a locking washer, came out too. I've been through the walkthroughs but I can't see where this washer goes. Can someone help a brotha out? Thanks. |
| The only lock tooth washer I can recall is the one for the back retaining plate. The screw up thru the grip that holds the trigger pack in could use one, when I took mine apart tonight it was pretty lose. Like I said just had mine apart their was no lock tooth washer in the lower. |
| Thanks, I looked through the blown up schematics again and then saw your reply. You are correct. Feel good, swapped out the screws and installed the buffer. Also put the handguard with the 3 rails and forgrip on. Also got the mag clip holder. Looking good so far. Now I need a rail and sight. |
Armory Sponsor