Armory Sponsor
Posted: 12/12/2008 12:47:05 PM EDT
|
Greetings,
I am following the breakdown instructions stickied above but am having trouble removing the lower receiver. Steps Taken: - dry fired and have bolt closed - removed stock - removed lower receiver takedown screw - removed hex screw & lock washer - Required (missed this): Remove the silver block by sliding it down. - sliding lower to the rear At this point the lower sticks (about 1/2 inch to the rear). I tried to twist back and forth but it is not coming apart. It appears to me that the trigger mechanism might have something to do with it but I am not 100% sure on this. Am I doing something wrong or missed a step? Or is this just hard to get off? Thank You! |
|
Procedure:
1. Check, if the gun is decocked and unloaded. 2. Turn the gun upside down (figure 13 ) 3. Remove the screws of the stock and of the frame. (figure 13) 4. Check, that the chamber is empty. 5. Remove the stock (figure 14) and unscrew the breech-fixing-part with the multitool (figure 15) 6. Remove the breech fixing part with the multi-tool or by hand. (figure 16) 7. Remove the grip in the succession 1 and 2 (first right then upwards) as shown in (figure 17) 8. Now you can pull out the breetch housing. (figure 18 |
|
Ok, found out what I was doing wrong.
In Step #3 (Remove the hex screw from inside the back of the upper receiver and be careful not to lose the lock washer. Simply side down the block and remove it.) I did not remove the silver block. I thought the directions were talking about the hex screw and lock washer only (the second part made me have a big huh look). |
Armory Sponsor