AR Sponsor
Posted: 6/13/2009 9:18:28 AM EDT
|
so here's my problem. Just bought a RRA 9mm. It has the proprietary lower receiver for 9mm, with a 9mm hammer. The only trigger modification i did was to install KNS non-rotational pins.
I started off last week having problems after a few rounds and thought it was related to just being a new gun. Now the problem is much worse and I can't get off more than one or two shots in a row. PROBLEM: I fire. The old round ejects, The new round chambers. I pull the trigger and it is slack, kind of like what the trigger does on last round bolt hold open. The creepy thing is that the bolt is fully returned to battery, and the safety can be activated but the hammer does not drop when i pull the trigger. HELP! Any suggestions? I don't want to have to send it back to RRA because i bet it wil take them months! |
| I hope someone has the answer to this. I have a RRA 9mm inbound and was planning on doing the same thing. Without the knowledge of never having installed the pins before, the only thing I would look at is the hammer spring. Are your spring legs sitting on top of the pin in the recesses, or did they slip/fall under it during installation? Good luck with this problem, please post when you find the cure. |
| You might have better luck getting an answer in the Rimfire and Pistol Calibers Forum where the 9mm guys hang out. |
AR Sponsor