AR Sponsor
Posted: 4/23/2016 2:29:01 PM EDT
| Anyone have any experience with Gorilla Machining 9mm barrels? At 90$ their price is looking pretty attractive. |
|
I have blanks on the floor.....and 5 inch barrels in stock...pretty much sold out of everything else.....if you can tell me what you need I can pull a blank and manually run one for you if you are in a hurry, The 5 inch barrels we have in stock are nitride coated.....the manually made one would be 4140 CM with cerokote. Hope to be running 9mm in a couple of weeks......16's 8.3 and probably 5.5 inch......just have a large order of 45 barrels we are in the middle of making.
Rudy Edit: Found a complete 16 inch 9 mm upper today......  ....and a dozen 11 inch 9mm barrels.....
|
|
Quoted:
Just got mine, haven't tried it yet. But now I'm kind of iffy to, considering it's got a tirant 9 on the end of it. If you have dial calipers....measure the wall thickness of the muzzle threads from the groove to the OD thread surface....if it is within a couple of thousandths on all points you should be good to go..... I'd also measure the breech end from OD to chamber wall.......in at least 4 places 90 degrees apart. It should measure within a couple of thousandths on each as well. Also measure the protrusion of a loaded round....it should be .130 to .140 from the breech face....assuming your bolt pocket is .125......and it should be with the bolt you have. |
AR Sponsor