Warning

 

Close

Confirm Action

Are you sure you wish to do this?

Confirm Cancel
Member Login
Site Notices
10/20/2017 1:01:18 AM
9/22/2017 12:11:25 AM
Posted: 10/6/2005 10:49:20 AM EDT
I am about to install a low profile gas block that goes on with set screws, so my question is what is the prefered install method? Do you drill holes in the barrel so that the set screws have something to sink into or do you tighten the snot out of them and use loctite to keep them from backing out?

Link Posted: 10/6/2005 11:46:31 AM EDT
Link Posted: 10/6/2005 1:03:45 PM EDT
Sounds good, thanks.


Top Top