AR Sponsor
Posted: 3/1/2008 12:30:33 PM EDT
|
I know its just pics of a RRA stripped lower, but I'm really excited about my first AR15. I just ordered a RRA LPK and 6 position RRA stock form Legal Transfers. I also ordered a couple of C-Products black marlube aluminum 30 rd. magazines from Denny's. I plan to order a RRA entry tactical upper, when funds permit. I also plan on using EOtech optics. The primary use for the rifle is home defense/recreation. What will make life easier for the assembly of the Lower receiver? I plan on purchasing roll pin punches, a good brass hammer and a stock wrench from Brownells. Am I missing something? Your suggestions are greatly appreciated.http://i107.photobucket.com/albums/m285/Senorx470/RRALower1.jpg http://i107.photobucket.com/albums/m285/Senorx470/RRALower2.jpg |
|
There is a tool that helps putting the detents in on the front and rear pins. That is a good one to have. This tool ETA : Link to tool Good luck with your build, and post pics when you are done. |
| I'd press the roll pins in using vice grips as described here www.ar15.com/forums/topic.html?b=3&f=4&t=226782. I think it poses less potential to marr/damage you lower. |
AR Sponsor