AR Sponsor
Posted: 7/30/2008 5:52:08 PM EDT
|
My bolt catch works fine during use. It locks the bolt back and there are no issues. I also keep my actions open while in storage. With the bolt locked back, if I bump the gun, the bolt closes. This can't be normal, can it? http://i275.photobucket.com/albums/jj296/dispatch55126/DSCF0950.jpg http://i275.photobucket.com/albums/jj296/dispatch55126/DSCF0958.jpg |
Correct. If the bumping of the rifle has sufficient force to push the bolt back far enough off the bolt catch, the bolt catch will retract allowing the bolt to ride forward. |
That is not a good idea for long periods of time. You would not want your buffer spring to take a set at a shorter length than what it is causing problems later on down the road and leaving your trigger cocked back could result in the same way. The way I was taught was bolt forward, on semi, trigger pulled, and port door closed for storage. |
Here is the spring questions again. Everyone has different opinions. Its my understanding that its the cyclic action that breaks down a spring, not compression unless it goes beyond its compression range. You are correct that the bolt is closed and the dust cover is closed when in the armory. The armorer is also suppose to inspect those rifles regularly for wear. Personally, I'd prefer to have the action open to allow air circulation as well as let any remaining oils seep out vs. risk having moisture rust a component or have oil gum up the firing pin. |
AR Sponsor