AK Sponsor
Posted: 7/5/2019 12:15:31 PM EDT
[Last Edit: 545_7n6][Edited]
|
I have a recently purchased, but 2014 marked trunnion Romanion RH-10, which is closely related to a wasr, just with a different sighting system essentially. Ive had 2 failures to eject in the last 350 rounds, where the empty casing is slamming into the top of the barrel horizontally (opposite of a stove pipe). Normally the ejection sends the brass 30 feet, but sometimes it lands half that distance. I have done some reading about these new production Romanian AKs having bad extractors. I was wondering if this is the likely cause before I buy a new extractor. This usually happens after a magazine or 2 when the barrel is getting warmed up. Also, the gas tube has no holes in it to let off excess gas, it does seem to be pretty overgassed but I don't know if that would be the issue for failures to eject, considering most AKs are overgassed, and the fact that ejection seems to vary. |
|
Yes, if the extractor loses control of the fired case it can exhibit FTEj. Detail strip and clean the bolt, and while it's apart look for chips or dulling on the extractor and for a weak extractor spring. While the bolt is out look for peening on the ejector and any abnormal wear in th ejector slot of the bolt. AJ |
|
Not razor sharp.
This really means the extractor should taper to a narrow but not sharp edge with a slight flat. Look for excessive wear, chips, or deformation of the actual extractor edge. Also for the gas tube, look for notches on the front end. Early gas tubes had holes, later tubes have notches on the front edge to vent excess gas. |
AK Sponsor
Join the Community
Your next conversation starts here.
Create your free account to join discussions, share your experience, save topics, and connect with the AR15.COM community.
- Join discussions
- Follow topics and replies
- Connect with fellow enthusiasts
Already a member? Sign in
Stay informed by subscribing to our Newsletter