Posted: 10/17/2024 8:27:45 PM EDT
|
Been eyeballing these damn micros for a while now. Finally bought one. Found it better for me to buy the slide and frame separate since the frame came with 2 mags and they didn't have the configuration I wanted at the time. Picked it up today and already added some parts to it. In case any one was wondering, Glockstore's +3 extension for the Shield Arms mags will fit on the PSA mags. You just need to trim some of the plastic off the front lip after you remove the base plate.  Its a tight fit but it will lock in place. I chose to shave off some of the frame, just enough to see daylight between the frame and the mag. Fits a lot easier now.  GS's extended slide release fits too.  
|
|
Originally Posted By SpankMonkey: Nice build OP. Thx for the tip on the plus 3 extensions. Update on the +3 extensions. While they do fit on the mags, the follower keeps getting bunched up in the spring towards the bottom and rounds get loose and just fall out. I have ran 3 different kinds of mags and the modded PSA one still has issues. So I will be putting that one back to OEM and trying it again. |
|
Originally Posted By -Shaggs-: Update on the +3 extensions. While they do fit on the mags, the follower keeps getting bunched up in the spring towards the bottom and rounds get loose and just fall out. I have ran 3 different kinds of mags and the modded PSA one still has issues. So I will be putting that one back to OEM and trying it again. Copy. I'll hold off on getting one. Let me know how it runs on the OEM mag. |
|
Originally Posted By SpankMonkey: Copy. I'll hold off on getting one. Let me know how it runs on the OEM mag. Back to OEM form and it functions just fine. I did notice the spring inside the mag is different shaped that what a Glock or SA mags have. Those have the same springs size the length of the spring. PSA is a big ring, then small ones, then big rings again. It alternates the whole way. |