Posted: 5/25/2026 12:36:49 PM EDT
|
Recently picked up a used CSX at my buddies shop. Ordered an AIWB for it from c&g holsters. Trying to come up with a reason to not start carrying it. Ran 115 fmj, 124 fmj as well as 200rds of 147gr HST through it. No issues at all. From the draw this little guy just comes right up and point naturally. Ordered a set of CS R3D sights for it. Sights should be here by the end of the week. Once I put them on I will get out back and see how I like them. I expect I will. At that point I will probably start carrying it. Been carrying an Sig 365x with a Radian Ram Jet set up for a while now. This little CSX just disappears when I put it on and shoots so dam well. Wanted to see if anyone else is carrying one, if so, any issues etc. thanks in advance. Stay safe. |
| The 3.6 CSX-E, is my daily carry. Its actually one of the pistols I shoot the best. Comfortable and easy to carry. Not one.complaint. I put it with the 12 round mag in my fanny pack when i jogging. I put it in a holster with the 15 round to carry all day long. |
Six
|
Picked up Amy 3.6” yesterday. The trigger is pretty heavy. My trigger pull gauge maxes out at 8 pounds and it is heavier than that. The pull is clean and the reset is distinct. I’ve got an email in to S&W to see what they say about the weight. |
Charlie Kirk lives on in all of us!
|
Got mine back from S&W yesterday. The trigger was still over 8 pounds. The service ticket said replaced trigger and test fired. I don’t think they actually did anything. Took it to the range and it functioned fine, but the trigger made it very blah. Heavy and gritty. I tore it down to the frame when I got home. The trigger bar was really rough. I polished the trigger bar, sear, and trigger pin. It’s a lot smoother now and around 6.5 pounds. Anybody know where to start for a replacement hammer spring? I’d like to try clipping a couple of coils. |
Charlie Kirk lives on in all of us!
