Posted: 3/28/2026 5:26:23 PM EDT
| has anyone checked the supplied screw length after mounting the eps carry on the new k cut? The best i can tell when using the 10mm m3 screw(actually 9.6) there is about 1.36 mm between extractor rod and screw end. This is not a torqued measurement this is just measuring everything and doing math the best i can so not sure how much deeper it goes when torqued. There is roughly about 3.29 mm of screw below the eps so i may take off a .5-1mm. There is about 5.21mm from top of slide to plunger. |
|
I haven’t checked anything besides function check. Mine has been fine with factory screws. Attached File |
Free men do not ask for permission.