I still have a few disconnectors (frt) for the TX-22.  They are made from 4130 chromoly steel.  I measured the OEM disconnector and it is 0.084".  These are the proper thickness, 0.084".  I ground them on a surface grinder.  The surfaces are very, very smooth, you can see the flash reflection on some of the parts in the picture.

I want $10 dollars shipped.  I will accept Paypal F&F, or face to face.  I will ship anywhere in the contiguous US.  If your state doesn't allow them, that is your responsibility.

These will ship in a letter envelope with a postage stamp, therefore you will not receive a tracking number, it's a letter after all.

The video below verifies it functions.  And I have 100% feed back, with many repeat buyers.

The one hiccup at the end of the video was me letting off of the trigger, but as soon as I pressed it again the rest of the mag emptied!  Because it is verified to work all sales are final.

I was shooting Federal Automatch 40grain 1200fps.  It ran flawlessly, as you can see.  I tried one mag suppressed with a silencerco sparrow, but the ammo didn't cooperate.  I think Federal CCI may run good with the sparrow.

I cannot be responsible for your gun/ammo combo. There have been no issues reported yet. I really do not think anyone will have problems with these.  Mine runs with just what I had laying around.

Here is a link to a video of the gun running the disconnector.  It is fast!

IF YOU WANT FEEDBACK, LEAVE FEEDBACK.  I'm done leaving feedback for buyers that then don't leave feedback for me.

tx22

https://www.youtube.com/watch?v=63BqKhz8OgI