Posted: 2/4/2020 4:01:06 PM EDT
|
THOUGHT I had read this on ARFCOM - but searching the site for a while either gives "500 error code" messages, or no result
May want to go down this route for a couple of competition magazines, so ideally I need a link to the article if anyone knows where it is? Thanks |
www.mooreleather.co.uk
| I have tried 3d printed "follower upgrades" on several guns and they universally suck. Typically what you gain in capacity you will lose in reliability, in my experience. For example I made +2 followers for some GSG/SIG mags. I have 1 mag that will hold 12 and about 80% of the time feed all 12. The rest are worse, down to one that will feed 2 rounds and then jam every single time. I have swapped followers and measured everything I can with a micrometer trying to sort these out, but the solution evades me. I have had similar results with S&W .22 magazines. Good luck in your quest, but I wouldn't be hopeful.... |
You got gun law problems, I feel bad for you son. I got 99 problems but a ban ain't one. -Sylvan
