AK Sponsor
Posted: 4/14/2019 4:19:25 AM EDT
[Last Edit: Capt_Destro][Edited]
|
I'm trying to remove a Romanian trigger group to install an American Trigger Group.
So far I've had no luck with applying downward pressure on the spring and removing the front most pin. Any tips? I've been watching youtube videos and it looks easy. In my case it is not. This is a new rifle kit and parts were initially tight. Pressure was applied and I cannot drive the pin out. It appears only a punch with no hammer is needed. No luck so far. |
| I had three AKs all Russian that I did internals replacement on. One of the three had a different sherpards hook that was a real PITA to get out. Had to analyze it differently than the others which were like the youtube video ones. It has been some time since then, but iirc I had to pull up in the end. Take your time to figure out this particular one, come at it from a different angle or if all else fails cut the wire. |
|
Originally Posted By Speeddemon02:
I had three AKs all Russian that I did internals replacement on. One of the three had a different sherpards hook that was a real PITA to get out. Had to analyze it differently than the others which were like the youtube video ones. It has been some time since then, but iirc I had to pull up in the end. Take your time to figure out this particular one, come at it from a different angle or if all else fails cut the wire. |
AK Sponsor