Written By: Thorgul
Photos By: BlueOrbit
Page 1 | Page 2 | Page 3
7. The rest is easy. Remove the hammer pin. Push it from the right and pull to the left.
Click On Image For Closer Look
8. Remove the hammer. Turn it half way, so that it can slide out.
9. Remove the trigger pin. Push the disconnector down, to let the pin go.
Click On Image For Closer Look
10. Remove the trigger and disconnector as a whole, just lift it out of receiver, and try not to loose a small spring between them.
This is it. Assemble in reverse order:
1. Put together the trigger and the disconnector, and drop them as whole into receiver. Insert trigger pin, while pushing on disconnector to let the pin in.
2. Slide the hammer in, turn it 90 degrees, and insert the hammer pin.
3. Insert the wire pin flat, get it under the trigger pin grove first, and then flip it into vertical position, open end facing upward.
Click On Image For Closer Look
Using screwdriver, get the hammer spring coils out of the way, and push the wire pin all the way on to a hammer pin. Make sure it clicks, and is seated in the grove fully and firmly. Make sure the rear end of the wire pin did not get out of proper position under the trigger pin grove.
Page 1 | Page 2 | Page 3
Photos By: BlueOrbit
Page 1 | Page 2 | Page 3
7. The rest is easy. Remove the hammer pin. Push it from the right and pull to the left.
Click On Image For Closer Look
8. Remove the hammer. Turn it half way, so that it can slide out.
9. Remove the trigger pin. Push the disconnector down, to let the pin go.
Click On Image For Closer Look
10. Remove the trigger and disconnector as a whole, just lift it out of receiver, and try not to loose a small spring between them.
This is it. Assemble in reverse order:
1. Put together the trigger and the disconnector, and drop them as whole into receiver. Insert trigger pin, while pushing on disconnector to let the pin in.
2. Slide the hammer in, turn it 90 degrees, and insert the hammer pin.
3. Insert the wire pin flat, get it under the trigger pin grove first, and then flip it into vertical position, open end facing upward.
Click On Image For Closer Look
Using screwdriver, get the hammer spring coils out of the way, and push the wire pin all the way on to a hammer pin. Make sure it clicks, and is seated in the grove fully and firmly. Make sure the rear end of the wire pin did not get out of proper position under the trigger pin grove.
Page 1 | Page 2 | Page 3