I can thread the barrels 1/2-28 for you. The barrels must be at least 16.25" from the bolt face to the muzzle. I have run across several so-called 16" barrels which have a recessed muzzle; if they were to be threaded, the barrel length would fall below 16" and would be subject to NFA rules. I can use barrels which are shorter, but they will have to have the flash hider permanently attached. I can also do short NFA length barrels, but I need verification of registration with the NFA branch.
Here are the fees I charge for barrel threading:
If you provide a stripped baqrrel (removed from the upper receiver): $35.00
If the barrel is attached to the upper receiver and requires dismounting and remounting: $55.00
If the length of the barrel is too short and requires a flash hider to be permanently attached, this will add around an extra $15.00. You probide the flash hider to be used.
My hours of opperation are by appointment only and can run from 8:00 AM to 8:00 PM including some weekends. Turnaround time is usually less than 48 hours and may be the same day in some cases. I am located in Spring, Texas, near I-45 and FM 2920. As the gun 'biz is not my primary occupation, my schedule can be erratic. I will always try and work with you to get the work done as soon as possible as I know what a pain it can be to have to wait.
Keith
NFA Investments, A BATFE Licensed Firearms Manufacturer
Keith Norman, owner
Tel. (281) 639-0026
Type 07 FFL / Class 02 SOT
Web: www.NFAinvestments.com
Email:
[email protected]