Im hoping to find someone thats actually done a Nova or Supernova before because its kind of an odd receiver. It has a polymer shell with a skeletal steel receiver on the inside. I'd do this myself if it were solid steel or aluminum.

I need 4 holes drilled and tapped so I can mount a Mesa Tactical side saddle and 6" top rail combo.

Im located in Anoka County and know of a few good smiths around the area but im hoping there's a chance someone else might have had this done on the same gun.

Any suggestions?


Thanks!

Cory

Craig's Gunsmithing. 787 Tower Drive Medina, MN 55340 (612) 860-7697 give the fellow a call and run it by him

Thank you, ill give him a call tomorrow.