Thanks for the tips guys.
After looking around a bit, I've found three benchmades that look pretty nifty and feel good in my hand, Only one question.
I'm not quite in the know about steels. I've tried to do some research but am having a bit of trouble making sense of it as most of the descriptions aren't very good and make them sound pretty similar.
The ones I'm liking right now are
941 Osborne - 154CM
710D2- D2 Tool steel
921 Switchback - S30V
Basically I'm looking for anything you've got to say about those steels, and if the answer can be given which one is the best.
Thanks again!
Edit: in case it matters, my sharpening is done on a polishing wheel, from my experiences I get a disgustingly sharp edge in a few minutes. As opposed to my terrible ability at hand sharpening