Xdm 40, Sig p226, and M&p shield are a few of the guns I have owned but didn't like for one reason or another. The M&p 9 and 9c are my favorite pistols so far. To make them the best they could be I sent them to ATEi for some work. Previously I stippled the grips myself and undercut the trigger guard. Chose 10-8 fiber in front and blacked out in the rear.

At first i had some questions about some specifics on the guns, but I was put at ease over the phone and was ready to send them in. The triggers were lightened and polished to 4.5 lbs and the reset was made audible and enhanced. The triggers are awesome. The slack is smooth, the break is crisp and the reset is short and audible. A very good trigger, better than my old sig for sure. The slide work is beautiful and functional. The slides rack with one hand no problem and my press checks are done with ease and confidence that my hand won't slip. The guns were finished and shipped under the quoted time and I could not be happier with the work that was done. I love these pistols
http://i1274.photobucket.com/albums/y434/Zac_Pictor/image_zpsa255bbc2.jpg
http://i1274.photobucket.com/albums/y434/Zac_Pictor/image_zpsfb3fa76f.jpg
http://i1274.photobucket.com/albums/y434/Zac_Pictor/image_zpsb515c07b.jpg
Family photo just for fun
http://i1274.photobucket.com/albums/y434/Zac_Pictor/image_zps03a24897.jpg

How long was turn around?

Little under three weeks.

Nice work.  I want to get that work done on my M&P 9 real bad. I would also love to get a 9c and have them put a RMR on it

I've got to send mine off for that. Looks perfectly done.

I might have this done to my 9C as well.  My Glock 17 is currently with Doug for RMR install.

I should have mine back in a week and a half (M&P9).  Will have a full top and side serrations, 360 Aggressive stippling package as well. The whole top end got nickel boron'd

APEX FSS trigger shipped this morning. It should be an awesome range/carry package when I get it done.

Placeholder for future pics

Looking forward to pics!