I had a really hard time finding a rear sling swivel so i decided to make my own, what i did was take a standard AK sling swivel found on most wooden stocks, I used the swivel loop as the doner, i was going to cut down a piece of 16 guage steel but decided to use an old hack saw blade. The slot i cut in the receiver was in accordince with the template on "pookies" site, i trimmed down all the saw teeth on the blade on the bench grinder to just inder the slot size "i like a tight fit." Once i decided on the length (i never took a measurment) of the hacksaw blade, i cut it to length. I then put the blade through the loop and bent it by hand first then i crushed it to take form around the loop in the vise. I then inserted it into the slot and pried the two ends apart from eachother, then i took a c-clamp and bent each end almost flush with the inside of the receiver. Heres some pics of the finish product. McM