Will the bulgy hardware...I.E. rear trunnion, and front latch work with minor fitting on my AK-100 polymer buttstock?

I know about the different pin size 4.5 bulgy, and 5.5 for AK-100. But besides that.....Any major problem?

Someone had pics of both full sets. Bulgarain triangle folder, and AK-100 polymer folder.

Were the front locking latches curved differently?

Link?

I'm in-line to buy some Bulgy hardware. Want to know if it will work with my AK-100 Buttstock, and stamped Saiga receiver......

TIA

I just did a long post on this exact topic.  Look me up it had pics.  

Short answer is yes your poly will fit the bulgy hardware AFTER you remove some material from either the poly folder or the bulgy rear trunion.  I chose the bulgy as it is the least expensive part.  If you slowly remove material you can attain a nice tight fit.

Thanks.

And the front latch? a match?

Perfect match.

Quoted: I just did a long post on this exact topic.  Look me up it had pics.   Short answer is yes your poly will fit the bulgy hardware AFTER you remove some material from either the poly folder or the bulgy rear trunion.  I chose the bulgy as it is the least expensive part.  If you slowly remove material you can attain a nice tight fit.

I remember seeing your pics. Do you have a link? Thanks. I am going to buy the hardware.

I do hope that this hardware comes back in stock with folks here in the US.

Folding Hardware thread