Can anyone tell me how to install the pin retaining wire that comes in a Romanian kit?  I have built two guns and can't figure out how the pin retaining wire is supposed to be installed.  I am installing the Tapco G-2 FCG and can't figure out how the wire goes in.  I have used E-clips with some success but would really like to use the origional wire.  Any advice and/or pictures would be fantastic.   Thanks!

hope this helps  http://www.gunsnet.net/Linx310/fcgremoval2.htm   hug.gif

You have to clip the coil and reshape it.

Throw it away and use E clips.

My standard answer is to get an L shaped wire retainer.